Balter IP-D1231VR Manual page 21

Reattach the camera to the junction box by putting
8.
the spigots (10) into the grooves (9), then insert and
tighten the Allen screws (12).
Unmount the lens cover (19) to gain access to the microSD cardslot (16), the analogue video output (17)
10.
and the lens zoom/focus control (18).
Insert a microSD card (up to 128GB) into the microSD cardslot.
11.
You can connect an analogue service monitor to the analogue video output (16) to
12.
immediately check the image settings on site. Using the joystick you can control zoom
and focus.
`
Use the webclient to conveniently adjust the image settings once the camera is turned on
and connected to the network (see page 30).
To adjust the camera vertically and turn it around
9.
its own axis loosen the screw on the joint (11) und
adjust the camera as desired. Tighten the Allen screw
again once you're done.
21