Cleaning; Troubleshooting - APW Wyott XWAV-1422 Installation And Operating Instructions Manual

Insure the appliance has been turned off and has had sufficient time for all surfaces to cool down before
cleaning. Use only mild soap and water to clean this appliance. Appliance cleaning should be performed
daily.
NOTE: DO NOT USE ABRASIVE PADS OR CLEANING SOLUTIONS ON THIS APPLIANCE.
Daily Cleaning
!
Remove the crumb pans and wipe out debris with a damp rag and mild soap solution.
!
Remove the deflector panels located at the entrance and exit of the oven tunnel. Wipe down the
area under the deflector panels, and the deflector panels, with a damp rag and mild soap. Reinstall
the deflector panels by reversing the procedure used to remove them.
!
Using a damp rag with mild soap and water, wipe down the exterior surfaces of the appliance.
!
Using a damp rag with mild soap solution, wipe down all areas of the conveyor. DO NOT ATTEMPT
TO CLEAN THE UPPER WHITE CERAMIC, OR LOWER METAL HEATERS.
!
When units are in the stacked configuration, it is still necessary to clean between the units. Using a
damp rag with mild soap and water, wipe down the tops and undersides of all units. Ensure there
are no foreign objects between the units that could catch fire.
!
Using a damp rag with mild soap and water, wipe the surfaces of the stacking spacers on all four
corners.
Always ask and check the following:
Not getting power:
1. Is the unit connected to a live power source of the proper voltage?
2. Check the rating label. Is the unit connected to the correct power source?
3. Check the circuit breaker.
4. Is power switch "ON" and led displaying information?
5. If the above checks out, and you still have problems, call your local service agent.
Conveyor not working (NON-EZ MODELS):
1. Please refer to "Not getting power" section.
2. Is the knob turnedto correct setting per desired speed?
3. Note: At slower settings the conveyor moves very slow and may appear stalled, which is not the
case.
4. If the above checks out and you still have problems, call your local service agent.
Conveyor not working (EZ MODELS):
1. Please refer to "Not getting power" section.
2. Check belt for obstructions. Belt may be jammed.
3. Reverse belt direction to check for belt jam - locate Reversing Switch on left side, beneath conveyor
frame, hidden by removable cover. Remove cover, flip switch, and note if belt begins to move
backwards. Does belt move backwards?
4. If YES , then clear belt jam and reset belt direction via Reversing Switch.
5. If NO , then call your local service agent.
6. Note: At slower settings the conveyor moves very slow and may appear stalled, which is not the
case.
7. If the above checks out, and you still have problems, call your local service agent.

6. CLEANING

7. TROUBLESHOOTING

14