Advertisement
Re-configuring the output driver:
To re-configure the Three2one's output driver you must carefully
remove the DC power and then remove the 3 input jack plug nuts and
loosen the out and in jacks. Then unscrew the four screws on the end
of the Three2One. The bottom plate now can be removed, and you'll
see the DIP switches.
Your Three2one has 4 output driver configurations.
bypass)
there will be an increase in signal level of X4 instead of X2.
always buffered.
*Note: This would limit the input handling; however, the X4 gain in the
Three2one can still handle inputs of 4V signal peak to peak.
GigRig Ltd,
© The
rights reserved. Design rights claimed. Moral rights asserted.
1, True bypass (output direct connection, no amp or
buffer) is selected by an internal mini dip switch; this is
the default mode.
2, Always buffered: this is for systems where long
cables need to be driven with a low impedance to
create a crisp top end to all your sounds. (Never true
3, Always X2 - this gives the same benefits as 2 but now
has the added option of increasing the drive range
available*. With the gain control turned all the way up
4, Single Input Cycle: This mode enables you to use a
single input and toggle through the different preamp
levels. You don't need a preamp engaged but it is
2016. Business Reg: 05731704 / VAT: 884568858. All
Enjoy!
Advertisement
