Advertisement
What do the functions do?
Red
'on':
This means your Three2one will always step through all three inputs,
even if an instrument is not plugged into input 3, the Red input.
Tip... if you want to have a single input and scroll through the different
pre amp levels, you need this function to be turned on.
Green
'on':
This adds a 'mute' to the guitar selection sequence so now the new
sequence will be Blue,
Green,
Red,
Mute, Blue,
Green,
Red,
Mute;
And so on. This also applies to the two-guitar setup which will then be
Blue,
Green,
Mute, Blue,
Green,
Mute; and so on.
*Blue
'off':
Blue
will always be 'on' in the standard modes, but turning it off allows
you to blend between the guitars which have the amplifier/ buffer in
the signal path.
This allows two or three guitars to be played at the same time though
the Three2one, it will blend them together with the volume controls as
balance controls.
When in Blend Mode the foot switch will cycle through all the
combinations of the three inputs. This setting will not be memorised
by Three2one so it won't affect any of your other settings.
Experiment and have fun; even line level devices such as drum
machines or keyboards can be blended with your guitars!
Tip: You can exit back to normal mode, at any time, by simply
removing and reconnecting the DC power.
GigRig Ltd,
© The
2016. Business Reg: 05731704 / VAT: 884568858. All
rights reserved. Design rights claimed. Moral rights asserted.
Advertisement
