Chicco 000.71553.000.000 Manual page 9

• Place the feeding bottle warmer only on flat, stable surfaces, out of reach of children. Never place the
equipment near cradles or cots, since, during use, the container and the water contained in it become
very hot. Always use and handle the equipment with the maximum care!
• Never place the feeding bottle warmer on top of, or near hot surfaces, gas rings or electric hot plates,
or on delicate surfaces sensitive to heat and/or humidity.
• Never operate the feeding bottle warmer without water inside the heating chamber.
• Only use feeding bottles made of heat-resistant plastic or thermo-resistant glass: do not use disposable
feeding bottles.
• Do not move the feeding bottle warmer during use or when it still contains hot liquids.
• After use, always allow the feeding bottle warmer to cool down completely.
• When not in use, and before cleaning or storing the feeding bottle warmer, always disconnect the
power cable plug from the mains socket, and let it cool down completely.
• Before feeding baby, always check the temperature of contents (it must not exceed 37°C).
• For hygiene and health reasons, feeding bottle warmers must only be used to warm up pre-cooked baby
food, not to cook it. It is recommended to warm up food at 37°C. Never warm up food more than
once, or for more than one hour.
• The final temperature of the food and the heating time could vary according to the quantity of food
being heated, the initial (room or fridge) temperature, the density of the food, the position of the tem-
perature adjustment knob, as well as the type and size of feeding bottle used (plastic or glass feeding
bottle, baby food jar).
The use of any electrical equipment requires compliance with some fundamental rules.
In particular:
• The electrical system of the room must always conform to the safety regulations in force.
• Ensure that equipment voltage and frequency (see the rated voltage plate located underneath the
equipment) correspond to the voltage and frequency of the mains.
• Plug the equipment to a mains socket that is easily accessible.
• Do not pull the mains cable or the appliance to unplug the equipment from the mains.
• The feeding bottle warmer must be used in compliance with the instructions supplied.
• Do not leave the feeding bottle warmer exposed to atmospheric agents (rain, sun, etc.).
• Do not submerge or wet the plug, feeding bottle warmer, or power cable in water or other liquids.
• Never touch the feeding bottle warmer with wet or damp hands.
• Do not touch the feeding bottle warmer if it has fallen accidentally in the water. Should this happen,
unplug the equipment immediately and do not use it; contact a qualified technician or one of Artsana
S.p.A.'s authorised retailers.
• If the feeding bottle warmer is damaged and / or not working correctly, switch it off and disconnect the
plug from the mains socket; do not attempt to open the product, contact a qualified technician or one
of Artsana S.p.A.'s authorised retailers.
• Never leave the equipment unattended when in use.
• Do not leave the feeding bottle warmer switched on continuously for over 60 minutes.
• After one hour of continuous operation, the equipment must always be switched off and allowed to
cool down.
• The feeding bottle warmer can be opened only with special tools. To replace the power cable, only use
a cable similar to the cable supplied with the equipment. The cable must be replaced by a qualified
technician or one of Artsana S.p.A.'s authorised retailers.
• Incorrect repairs carried out by unqualified technicians may cause damage or injuries to the user.
• Dispose of any packaging, worn accessories, and/or the equipment at an appropriate differentiated
collection point, as required by the regulations in force in each country.
9