Chicco 000.71553.000.000 Manual page 10

This product complies with EU Directive 2002/96/EC.
The crossed bin symbol on the appliance indicates that the product, at the end of its life, must
be disposed of separately from domestic waste, either by taking it to a separate waste disposal
site for electric and electronic appliances or by returning it to your dealer when you buy
another similar appliance. The user is responsible for taking the appliance to a special waste
disposal site at the end of its life. If the disused appliance is collected correctly as separate waste, it can
be recycled, treated and disposed of ecologically; this avoids a negative impact on both the environment
and health, and contributes towards the recycling of the product's materials. For further information
regarding the waste disposal services available, contact your local waste disposal agency or the shop
where you bought the appliance.
IV. INSTRUCTIONS FOR USE
How to Prepare the Equipment:
Always ensure that the power cable plug is disconnected from the mains socket. Pour approximately
20ml of water into the heating chamber of the feeding bottle warmer (approximately, it is the quantity
of water needed for covering the bottom of the feeding bottle warmer). Insert the feeding bottle, using
the specific rack, or a baby food jar, using the specific support.
Warning: Never operate the equipment without water inside the chamber, or if the quantity of water is
below the minimum level of 20ml.
HOW TO WARM UP FEEDING BOTTLES
• After preparing the feeding bottle warmer as described in the paragraph above, place the feeding bottle
warmer on a flat, stable surface and connect the plug to a mains socket.
• After connecting the plug, the display will light up, indicating that the feeding bottle warmer is ready
for use.
• Select the feeding bottle warming up mode by referring to the following chart:
Program Number Program
0 Switched Off
1 Chicco feeding bottle
2 Chicco feeding bottle
3 Chicco feeding bottle
4 Chicco feeding bottle
5 Baby food jar
* The temperature reached can vary by ± 15%
• Turn the selector lever towards the icon representing the desired program.
• The display will show the number of the program selected.
• Press the ON/OFF switch (l) located on the right of the feeding bottle warmer; the equipment will start
the warming up cycle.
• During operation, the number of the selected program shown on the display will be substituted by a
sequence of running bars.
Feeding Bottle Initial Temperature
Capacity of Foodstuff
Approximately 20°C
120/150 ml
(room temperature)
Approximately 20°C
250 ml
(room temperature)
Approximately
120/150 ml
5°C (fridge)
Approximately
250 ml
5°C (fridge)
Approximately 20°C
(room temperature)
10
Water in the heating
Heating Time 37°C*
chamber (ml)
20 ml Circa 3'
20 ml Circa 4'
20 ml Circa 4' 20''
20 ml Circa 5' 55''
40 ml Circa 8' 30''