Parkside PFDS 33 B3 Operation And Safety Notes page 83

It is recommended that you always carry out
work with another person.
Push the flux-cored wire through the wire outlet
(see Fig. J).
26
Lead the wire along the feed roller
then push it into the cable assembly intake
(see Fig. K).
Pivot the pressing roller unit
of the feed roller
Mount the adjusting knob
Adjust the counter-pressure using the adjusting
knob in such a way that the welding wire sits
tightly between the pressing roller and the feed
roller
squashed (see Fig. L).
and
29
Switch the welding unit on using the main
31
switch
Press the burner button
Now the wire feeder system will push the weld-
ing wire through the cable assembly
the burner
As soon as the wire protrudes 1 – 2 cm from
the torch neck
button
28
(see Fig. L).
29
27
in the upper duct without being
29
.
5
.
12
.
11
you can release the burner
32
once more (see Fig. M).
12
Assembly
in the direction
(see Fig. L).
and
13
GB/MT 83