Advertisement
18
Operating your Clean&Charge
• Connect your Clean&Charge with the low voltage supply
cord to the mains electricity supply.
• Open the contact bow (13) by pressing the release
button (14). After shaving, switch the shaver off and
place it upside down into the Clean&Charge (without
having released the shaver foil).
• Select the operation mode by toggling with the mode
selector (15):
• «clean» (about 15 min)
• «clean» + «charge» (about 75 min)
• «charge» (about 60 min)
• The corresponding lights will come on.
• (With cord shavers, only the «clean» function can be
selected.)
• Slide down the contact bow to connect the shaver and
to start the selected programme.
• If no programme is selected, the default function «clean»
will be started.
• Do not interrupt a running programme, as it leaves the
shaver wet and not fit for use. If interruption is needed
nonetheless, press the release button.
• After a programme has finished, the corresponding light
will go out. Prior to the next shave, press the release
button to release the shaver.
• When the «cartridge» light starts flashing, the remaining
fluid in the cartridge is sufficient for about 5 more
cleaning cycles. After these 5 cycles, the cleaning
performance will be reduced and the cartridge has to be
replaced.
• When the «cartridge» light illuminates constantly, the
cleaning function is locked and a new cartridge has to be
installed.
Only then, the next cleaning cycle can be started.
• A cleaning cartridge should be sufficient for about 30
cleaning cycles. With daily use, the cleaning cartridge
should be replaced approx. every 4 weeks.
• The hygienic cleaning solution cartridge contains alcohol
which, once opened, will naturally evaporate slowly into
the surrounding air. Each cartridge, if not used daily,
should be replaced after approx. 8 weeks.
• Clean the housing from time to time with a damp cloth,
especially the opening where the shaver rests.
Subject to change without notice.
Advertisement
