Advertisement
Technical specifications
• Power consumption:
• 3 W when cleaning
• 7 W when charging
• Power supply: 100 -240 V 2/ 50 or 60 Hz
(automatic adaptation)
• Input voltage: 12 V
Before using Clean&Charge
Only applies for cordless shavers:
For the first charge of the shaver, connect
the low voltage supply cord directly to the shaver, charge
it for 4 hours and shave at least once.
Only then can the shaver be cleaned or recharged in the
Clean&Charge.
If the rechargeable batteries are discharged, select the
combined «clean» + «charge» programme rather than
the «clean» programme alone.
Installing the cartridge
• Press the lift button (12) to open the housing.
• Hold the cartridge down on a flat, stable surface (e.g.
table). Carefully remove the lid from the cartridge. Slide
the cartridge into the base as far as it will go.
• Slowly close the housing by pushing it down until it
locks.
Replacing the cartridge
After having pressed the lift button to open the housing,
wait for a few seconds before removing the used
cartridge.
Before discarding the used cartridge, make sure to close
the openings using the lid of the new cartridge, since the
used cartridge will contain contaminated cleaning
solution.
1
new
old
new
17
Advertisement
