ADTRAN NetVanta 5305 Quick Start Manual page 2

System controller module

Hide thumbs Also See for NetVanta 5305:

NetVanta 5305 System Controller Module

Quick Start Guide

ONNECT THE

ONSOLE

NTERFACE

Before connecting to the NetVanta 5305 CONSOLE interface you will need the

following items: VT100 terminal or PC (with VT100 terminal emulation

software) and a straight-through serial cable with a DB-9 (male) connector on

one end and the appropriate interface for your terminal (or PC) on the other.

Connect the DB-9 (male) connector of your serial cable to the CONSOLE

port on the rear panel of the unit.

Connect the loose end of the serial cable to the VT100 terminal or PC (with

terminal emulation software).

Open a VT100 terminal session to the NetVanta 5305 using the following

settings: 9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press

<Enter> to activate the ADTRAN Command Line Interface (CLI).

OMMANDS

More detailed documentation for configuring your ADTRAN unit is provided on the

ADTRAN OS System Documentation CD included in your shipment. For more

details on hardware setup, refer to the appropriate NIM Quick Start Guides and the

Hardware Installation Guide. For more detail on configuring your system, refer to

the ADTRAN Operating System (AOS) Command Reference Guide, configuration

guides, and technical support notes.

Quick Start Guide, 61200831L1-13C, July 2005

Technical Support 1-888-4ADTRAN (1-888-423-8726)

For more detailed documentation, visit us online at www.adtran.com.

P/N 1200831L1

1200831l1