Wooden Structure; Original Concrete Slab Structure; Steel Framework; Newly Set Concrete Slab Structure - Midea H2 Series Technical & Service Manual

Midea AC Fan Coil Unit
The footings shown in Figure 10.4.3 are optional. You can purchase them separately and install them as follows:
1. Put the footings beside the unit to be installed.
2. Place the mounting holes on the unit base into the corresponding footing locating pin and install screws
and *2 to fix the footing according to Figure 10.4.3.
②
Install the unit following the steps below in case it is ceiling mounted.
To match the existing structure, set the screw pitch according to the unit dimensions.
Secure the square rod on the beam to set the lifting bolts.
Directly set and use an angle steel for support.
Base

Wooden structure

Square bar material
Beam
Ceiling
Lifting bolt

Steel framework

Suspension bolt
Angle steel for support
Suspension bolt
Footing
Figure 10.4.3

Original concrete slab structure

Use embedded bolts, and pull bolts.

Newly set concrete slab structure

Set using embedded appliances,
and embedded type of bolts.
Knife-type
insertion piece
Base
Reinforced bar
Embedded
bolt (hanging
Sliding-type
and embedded
insertion piece
bolt of piping)
*2
①
47