Ingics iGS03W User Manual
Beacon gateway
Hide thumbs
Also See for iGS03W:
- User manual (21 pages) ,
- User manual (22 pages) ,
- User manual (22 pages)
Table of Contents
Advertisement
Quick Links
INGICS
Guide
Ver.01
iGS03W/M is a gateway to bridge the local BLE tags, sensors, or beacons to remote server/cloud by WiFi,
or LTE-M. Through an easy web UI interface, user can configure the Internet access to upload reports to
cloud server by TCP, HTTP(S), or MQTT(S). This guide is to help the user to figure out how to operate and
configure the iGS03.
Contents:
Overview
Block Diagram
SIM
WiFi
BLE
GNSS
Example case 1: The device is in fixed position:
Example case 2: The device is moving:
Payload Format
BLE
GPS
Buttons
Get default button
OTA
LEDs
Configuration
Web User Interface
System
Wi-Fi
INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM
TECHNOLOGY
Beacon Gateway
iGS03W/M User Guide
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Ingics iGS03W
Summary of Contents for Ingics iGS03W
- Page 1 Guide Ver.01 iGS03W/M is a gateway to bridge the local BLE tags, sensors, or beacons to remote server/cloud by WiFi, or LTE-M. Through an easy web UI interface, user can configure the Internet access to upload reports to cloud server by TCP, HTTP(S), or MQTT(S). This guide is to help the user to figure out how to operate and configure the iGS03.
- Page 2 BLE Configuration BLE-5 PHY Mode Active Scan Mode BLE Filter RSSI Threshold Payload Whitelist BLE MAC Whitelist Security Device Key/Certification/Server CA Upload LET Settings Auth Username/Password GNSS Settings NTP Setting Revision History INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
- Page 3 INGICS TECHNOLOGY INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
-
Page 4: Block Diagram
The iGS03 BLE gateway scans beacons(like iBeacon or Eddystone), proprietary tags, or BLE sensors then sends the payload to TCP, HTTP or MQTT server. Users can configure the transmit period and server endpoint through a simple web UI. There are two models, iGS03W and iGS03M, representing different uploading interfaces, WiFi and LTE-M. - Page 5 Coded Phy: BLE 5 long range in 100% duty cycle User can use following command to set BLE mode: (telnet console) BLE PHYMODE (1: 1M Phy only, 2: Coded Phy only) The default PHYMODE is 1, 1M Phy INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
- Page 6 Then GNSS will be enabled and continuously get position with 1 second interval, and it will send a GPSR report every 60 sec. You can also use the "GNSS INFO" command to get the latest coordinates. INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
-
Page 7: Payload Format
BLE5 Long Range ADV $LRSR BLE5 Long Range Scan Response $1MAD BLE5 1M ADV $1MSR BLE5 1M Scan Response Examples: $GPRP,CCB97E7361A4,CB412F0C8EDC,-49,1309696773206D65736820233220285445535429020106,1574921085 $GPRP,E5A706E3923A,CB412F0C8EDC,- 87,0201041AFF590002150112233445566778899AABBCCDDEEFF0000100C3BB,1574921085 $LRAD,51A88AD374B7,CC4B73906F96,-87,02010212FF0D0083BC280100AAAAFFFF000010030000,1574921085 $GPRP,0C61CFC1452E,E7DAE08E6FC3,-44,0201061AFF4C000215B9A5D27D56CC4E3AAB511F2153BCB9670001452ED6 (iBeacon, UUID: B9A5D27D56CC4E3AAB511F2153BCB967, Major: 0001, Minor: 452E) General format: $GPSR,<tag_mac>,<reader_mac>,<rssi>,yymmdd,hhmmss.ss,latitude,longitude,speed,hdop(,timestamp) INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM... - Page 8 Reset(default) button can be used as Over-The-Air(OTA) firmware upgrade. This firmware upgrade is through WiFi interface only. To use it, press it then power on, keep pressing till network status LEDs flashes. INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
- Page 9 (If SIM card is not used) RED LED ON (1sec) Connect failure Error RED LED blink (5sec on/off) Misconfiguration Error RED LED ON (5sec) LTE init failure Error RED LED ON (1sec) Button pressed Indication INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
-
Page 10: Web User Interface
AP. The related settings can be managed on this page. AP Mode SSID: The default name is IGS03 plus the last digits of the mac address. Security: Open, WPA-PSK, WPA2-PSK and WPA-PSK/WPA2-PSK are supported. WPA2-PSK is recommended. INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM... -
Page 11: Station Mode
AP w/ DHCP. If one wants to manually assign an IP address for iGS03, the DHCP client should be disabled. Once disabled, users should assign the IP, Netmask, Gateway, and/or DNS server. INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM... - Page 12 HTTPS Users can simply use https:// in URL to enable HTTPS. And users can also enable Server Root CA/User Client Certificate based on the server requirement. INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
- Page 13 Client Certificate based on the server requirement. For example, to enable AWS-IOT, the user has to enable MQTTS/ROOT CA/ Use Certificate options and upload certificate and private key in the security page. INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
-
Page 14: Common Settings
If the user selects to enable throttle control, iGS03 will keep the last record for each TAG/Beacon ID in the given interval(request interval). In this way, one can reduce the upload connections to the HTTP server. INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM... - Page 15 Users can set 6 entries of the payload filter to make sure only concerned information is received. BLE MAC Whitelist Set BLE MACs to configure the whitelist. Users can set 10 MACs to make sure only concerned information is received. INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
-
Page 16: Ntp Setting
To open the NTP Setting UI, click the “clock” icon in the UI header. User has to set the time server and the update period to enable NTP. Remember to save the setting and reboot to make the setting effective. INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM... - Page 17 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
-
Page 18: Revision History
REVISION CHANGES Dec 3, 2019 Initial release Apr 6, 2020 Update screenshots Jun 3, 2020 Update photo and diagram Jul 7, 2020 Update LED behavior Sep 24, 2020 Fix text and layout INGICS TECHNOLOGY CO., LTD. • SUPPORT@INGICS.COM • WWW.INGICS.COM...
Need help?
Do you have a question about the iGS03W and is the answer not in the manual?
Questions and answers