Download Print this page

Ingics iGS01 Quick Start Manual

Hide thumbs Also See for iGS01:

INGICS

AP NOTE 001

Ver.1

Introduction

The iGS01 gateway reads beacons(ex. iBeacon,

Eddystone ..), customized tags, or BLE sensors and sends

the information to the local TCP server, internet HTTP or

MQTT server. Following are some mostly used examples :

Diagram

By default, the iGS01 is in AP mode as a TCP

server.

I NGICS TECHNOLOGY CO., LTD. • JK.FAN@INGICS.COM • WWW.INGICS.COM

T ECHNOLOGY

iGS01 Quick Start Guide

Steps:

1. Connect to iGS01 WiFi AP

2. Use TCP client tool to connect iGS01 TCP server

3. You can see the tag/beacon information in your

TCP client tool

Table of Contents

Do you have a question about the iGS01 and is the answer not in the manual?

Page 1 TCP server Diagram Steps: 1. Connect to iGS01 WiFi AP By default, the iGS01 is in AP mode as a TCP server. 2. Use TCP client tool to connect iGS01 TCP server 3. You can see the tag/beacon information in your TCP client tool ...
Page 2 TCP client Diagram Steps: 1. Connect to iGS01 WiFi AP In this example, the iGS01 is a TCP client and connects to an existing TCP server through the external AP. 2. In the browser, open 192.168.10.1 3. set iGS01 to connect to your AP 4.
Page 3 HTTP or MQTT client Steps: Diagram In this example, iGS01 is a HTTP or MQTT client 1~3 are the same with “iGS01 as a TCP client” connects to the internet HTTP or MQTT server. 4. set iGS01 to connect to your HTTP/MQTT server 5.