Martin CleanScrape Operating Instructions Manual page 22

5. On the far side of chute:
a) Draw a centerline of the head pulley perpendicular to the conveyor belt
line (see Figure 6). Rotate the bottom side mount back as far as
possible in order to achieve at least 17° of belt wrap while not
exceeding the belt exit (see Figures 2 & 3).
b) If bolting fixed point bracket to chute wall, do the following:
(1) Position fixed point bracket on far side chute wall as shown
(2) Mark bracket hole locations.
(3) Drill or cut two 13 mm (1/2-in.) holes for screws in far side
(4) Mount fixed point bracket to inside of far side chute wall
c) If welding fixed point bracket to chute wall, do the following:
(1) Position fixed point bracket on far side chute wall as shown
(2) Weld bracket to chute wall. Weld completely around
NOTE
If wide chute wall adapter is required, see Figure 14. Wide chute wall adapter kit, P/N
C1CP30000X. Bracket installation instructions are included in kit.
d) Install brackets (C) using nuts (D). Hand tighten nuts (see Figure 7).
e) Attach cleaner to far side bracket by inserting hex head screw and large
flat washer (B) through cable hook (A) and fastening with flat washer
and nut (C). Hand tighten nuts.
in Figure 6 (centerline install is used as an example).
chute wall.
using countersunk screws (B) and nuts.
in Figure 6 (centerline install is used as an example).
bracket. Do not skip weld
22 M4033ESA-06/20