Assembly And Installation - Glow Fire Bio Burner 24 User Manual And Safety Instructions

Thank you for choosing our bio ethanol fireplace. Bio-ethanol fireplaces are the environmentally
friendly solution for a real fire, without smoke, soot and ashes. They are suitable for living rooms
without a chimney and do not require a permit. Our fireplaces are made of stainless steel and / or
black powder-coated steel and impress with a modern concept.
Our bio-ethanol fireplace is a fireplace that you can use anywhere in the house or in your apartment.
Since bio-ethanol burns almost residue-free, ventilation through an open window is sufficient.
Before using the fireplace, please read the operating instructions carefully.
This product may only be sold together with this manual.
In the event of a resale, these instructions must be attached urgently.
Assembly & installation
For safety reasons, we recommend installation by specialist personnel.
It is recommended to install the fireplace with at least two or more people. Make sure the fireplace is
on a solid wall with non-combustible material. Please remove all packaging and packaging materials
before assembly and commissioning.
Installation of a free-standing fireplace:
- The free-standing fireplace is fully assembled and there is no further assembly
- required
- If you have a device with contact protection disks, these must be mounted using the brackets
provided.
- Make sure that the fireplace has sufficient stability. In addition, the fireplace must stand ab-
solutely straight. Measure this with a spirit level. Otherwise, ethanol may leak.
- Place the fireplace on a heat-resistant surface.
Place the bioethanol burner in the fireplace.
-
Filling, lighting and refilling the burner:
- Open the burner by pulling the slide
- Fill the container with bio-ethanol, please not more than 3/4 parts of each burner capacity.
Use a funnel for filling.
- Spilled ethanol must be removed with an absorbent tissue and the affected area cleaned
with water to avoid ignition outside the burner container.
- Long lighters or long matches are ideal when lighting bio-ethanol. Otherwise there is a risk of
deflagration. Under no circumstances throw used matches into the burner.
- If the flame does not ignite, please repeat the ignition process until the flame burns steadily.
After the flame has gone out, wait at least 30 minutes before restarting the fireplace. Other-
-
wise there is a risk of explosion.
The flame glows slowly and small at first. It can take up to 15 minutes to reach the optimal
-
temperature and flame height.
ATTENTION! The ethanol must be kept at a safe distance (min. 1m / 40 inches) from the fireplace. Do
not place the ethanol in front of the fireplace. Please note that ethanol sometimes burns bluish, diffi-
cult to see. So make sure the burner is always off and cold before adding ethanol.
Kamin User Guide & Safety Instructions
2