Keeping Your Shaver In Top Shape; Cleaning The Housing; Replacing The Cleaning Cartridge; Replacing The Foil & Cutter Cassette / Reset - Braun SERIES 7 760CC-4 User Manual

Series 7 Series 7
r e l e as e r e l e as e
Series 7 Series 7
r e l e as e r e l e as e
r e l e as e r e l e as e
old old
new new
Series 7 Series 7
r e l e as e r e l e as e
70S 70S
16
Alternatively, you may clean the shaver using the
brush provided:
• Switch off the shaver. Remove the Foil & Cutter
cassette
Using the brush, clean the inner area of the
pivoting head. However, do not clean the
cassette with the brush as this may damage it.

Cleaning the housing

From time to time clean the housing of the
shaver and the Clean&Renew station with a
damp cloth, especially inside the cleaning
chamber where the shaver rests.

Replacing the cleaning cartridge

After having pressed the lift button
housing, wait for a few seconds before removing
the used cartridge to avoid any dripping.
Before discarding the used cartridge, make sure
to close the openings using the lid of the new
cartridge, since the used cartridge will contain
contaminated cleaning solution.

Keeping your shaver in top shape

Replacing the Foil & Cutter cassette / reset
To maintain 100% shaving performance, re-
place the Foil & Cutter cassette
replacement symbol lights up on the shaver
display
cassette is worn.
The replacement symbol will remind you during
the next 7 shaves to replace the Foil & Cutter
cassette. Then the shaver will automatically reset
the display.
After you have replaced the Foil & Cutter
cassette, use a ball-pen to push the reset button
70S 70S
t
for at least 3 seconds to reset the counter.
While doing so, the replacement light blinks and
goes off when the reset is complete. The manual
reset can be done at any time.
Accessories
Available at your dealer or Braun Service
Centres:
• Foil & Cutter cassette 70S
• Cleaning cartridge Clean&Renew CCR
8
and tap it out on a fl at surface.
z
(after about 18 months) or when
2
to open the
8
, when the