Keeping Your Shaver In Top Shape; Replacing The Shaving Parts; Preserving The Batteries; Environmental Notice - Braun Series 1 190s-1 Manual

• Model 190s only: Switch the shaver on and rinse the shaver head under
hot running water.
• You may use liquid soap without abrasive substances. Rinse off all foam
and let the shaver run for a few more seconds.
• Next, (model 190s: switch off the shaver) remove the shaver foil (2) and
cutter block (3). Then leave the disassembled shaving parts to dry.
Alternatively, you may clean the shaver using the brush provided (c):
• Switch off the shaver. Remove the shaver foil.
• Using the brush, clean the cutter block and the inner area of the shaver
head. However, do not clean the shaver foil with the brush as this may
damage the foil.

Keeping your shaver in top shape

About every four weeks, clean the cutter block with Braun cleaning agents.
Put a drop of light machine oil onto the long hair trimmer and the shaver
foil (d).

Replacing the shaving parts

To maintain 100% shaving performance, replace your foil and cutter block
at least every 18 months or when worn. Change both parts at the same time
for a closer shave with less skin irritation.
(Shaver foil and cutter block: 10B)
Preserving the batteries (190s only)
In order to maintain the optimum capacity of the rechargeable batteries, the
shaver has to be fully discharged (by shaving) every 6 months approximately.
Then recharge the shaver to full capacity. Do not expose the shaver to
temperatures higher than 50 °C for extended periods of time.

Environmental notice

This product contains rechargeable batteries. In the interest of
protecting the environment, please do not dispose of the product in
the household waste at the end of its useful life. Disposal can take
place at a Braun Service Centre or at appropriate collection points
provided in your country.
Subject to change without notice.
For electric specifications, see printing on the special cord set.
18