Keeping Your Shaver In Top Shape; Environmental Notice; Before Using The Clean&Charge Station; Installing The Cartridge - Braun 3090cc User Manual

Keeping your shaver in top shape

Replacement light for shaving parts/Reset
• To maintain 100% shaving performance, replace the Foil & Cutter cassette (1), when
the replacement light for shaving parts (8) comes on after about 18 months or when
worn.
• The replacement light will remind you during the next 7 shaves to replace the
Foil & Cutter cassette. Then the shaver will automatically reset.
• After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for
at least 5 seconds to reset the counter.
• While doing so, the replacement light blinks and goes off when the reset is complete.
The manual reset can be done at any time.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has
to be fully discharged by shaving every 6 months approximately. Then recharge the
shaver to full capacity.

Environmental notice

Product contains batteries and/or recyclable electric waste.
For environment protection do not dispose of in household waste,
but for recycling take to electric waste collection points provided in your country.
Clean&Charge Station (C)
The Braun Clean&Charge Station has been developed for cleaning, charging and storing
your shaver.
During the automated cleaning process, the shaver is switched on and off at intervals
to obtain best cleaning results. Since the specially formulated cleaning fluid contains a
small amount of oil, the cleaning procedure also fulfils the lubrication needs of the
shaver.
Description
1 Start/release button
2 Contact bow
3 Lift button for cartridge exchange
4 Level indicator
5 Cleaning cartridge
Before using the Clean&Charge Station

Installing the cartridge

• Press the lift button (3) to open the housing.
• Hold the cartridge down on a flat, stable surface (e.g. table). Carefully remove the lid
from the cartridge. Slide the cartridge into the base as far as it will go.
• Slowly close the housing by pushing it down until it locks.
26