Page 24
English Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun Shaver. Read these instructions completely, they contain safety information. Keep them for future reference. Warning Your shaving system is provided with a special cord set, which has an integrated Safety Extra Low Voltage power supply.
Page 25
The cleaning cartridge contains a highly fl ammable liquid so keep it away from sources of ignition. Do not smoke near the station. Do not expose to direct sunlight for long periods of time. Do not refi ll the cartridge and use only original Braun refi ll cartridges. Description Clean&Renew station...
Page 26
Charging and cleaning the shaver Insert the shaver head with the front showing and released head lock (10) into the Clean&Renew. The contacts (17) on the back of the shaver will align with the contacts (3) in the cleaning station. Important: The shaver needs to be dry and free from any foam or soap residue! If required, the Clean&Renew station will automatically charge the shaver.
• To trim sideburns, moustache or beard, slide the pop-out long hair trimmer upwards. Tips for the perfect dry shave For best shaving results, Braun recommends you follow 3 simple steps: 1. Always shave before washing your face. 2. At all times, hold the shaver at right angles (90°) to your skin.
Page 28
Cleaning Automatic cleaning After each shave, return the shaver to the Clean&Renew station and proceed as described above in the section «Before shaving». All charging and cleaning needs are then automatically taken care of. With daily use, a cleaning cartridge should be suffi...
While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time. Accessories Available at your dealer or Braun Service Centres: • Foil & Cutter cassette 70S-3Z • Cleaning cartridge Clean&Renew CCR Environmental notice Product contains batteries and/or recyclable electric waste.
Trouble-Shooting Problem: Possible reason: Remedy: SHAVER Unpleasant 1. Shaver head is 1. When cleaning the shaver head with smell from the cleaned with water. water only use hot water and from time shaver head. 2. Cleaning cartridge is to time some liquid soap (without in use for more than abrasive substances).
Page 31
Shaving parts Reset button has not – Push the reset button for at least have been been pushed. 3 seconds to reset the counter. changed recently but replacement symbol lights up. 1. Drying time after 1. Clean directly after shaving to allow Shaver head is automatic cleaning enough time for drying.
Need help?
Do you have a question about the 7 Series and is the answer not in the manual?
Questions and answers