Introduction - Victor Pumps R250 Instruction And Maintenance Manual

Instructions

1. Introduction

1.1 The instruction manual contains important information on how to operate the pump in a safe,
adequate and effective manner. Compliance with these instructions will help you avoid dangerous
situations, reduce any repair costs and downtime, and improve the reliability and durability of the
pump.
1.2 The operating instructions refer only to the pump part. For the motor and the coupling cover refer
to the separate instructions.
1.3 The operating instructions must always be available in the place where the pump is in operation.
1.4 The operating instructions must be read and applied by all personnel assigned to work with the
pump.
1.5 The rules and regulations indicated in this manual must be scrupulously complied with, to prevent
accidents and protect the environment in which the pump is used. In addition, the local technical
and safety regulations necessary for the correct and safe use of the pump must be complied with.
1.6 The fundamental operations for the use of the pump, as well as for its transport, assembly,
installation, commissioning, maintenance and repair, must be carried out by qualified and
responsible personnel.
2. Safety
2.1 A pump can be dangerous if it is not installed correctly, if it is not properly maintained or if it is not
working properly. Failure to comply with the following warnings could compromise the safety of the
staff or the correct operation of the pump.
2.2 Each part of the pump must be used in full compliance with safety regulations. In the event that the
weight of the pumps or their accessories exceeds 20 kg, the use of special lifting devices is
recommended in order to avoid any damage to personnel.
CAUTION Lifting hooks suitable for lifting single elements such as pumps and motors must not be used to lift
the complete unit.
2.3 Before starting disassembling the pump it is advisable to take all the necessary safety precautions,
especially if dangerous or toxic products have been used in the pumps. If in doubt, contact your
Safety Manager or the pump manufacturer.
2.4 While disassembling the pumps that have used dangerous or toxic products, always wear adequate
clothing, safety glasses and protective masks.
2.5 Before disassembling, disconnect the pump electrically. Make sure that nobody can act on the main
switch during the work.
2.6 Before disconnecting the pump from the pipes, empty the product from the pump casing.
2.7 Rinse the pump casing with a compatible liquid and allow it to dry in a safe area.
2.8 Before proceeding with any maintenance, consult the system manager to verify the need for special
decontamination procedures.
2.9 All pumps returned to the manufacturer must be decontaminated and marked with a special label
that will state the precautions to be taken during disassembly.
3. Checking the delivery
3.1 Pumps and their parts are shipped duly protected to prevent damage during normal transport
operations. Nevertheless the goods must be inspected immediately after arrival. Any damage found
on the packaging, which might have also damaged the material contained, must be communicated
to the haulier and, if possible, accompanied by photographs too.
3.2 The photographic support will be useful in case of complaints to the haulier. Inform also the
company that sold you the pump.
3.3 Immediately notify the haulier in case of any material missing from what is indicated in the transport
document.
- Original -
B. Introduction
www.victorpumps.com
20010790 / 07.01.2020 / 3 - 22