3Com HomeConnect 3CP4130 User Manual page 9

I successfully installed the 3Com
USB driver, but after rebooting, I
cannot communicate over the USB.
The USB LED on the Dual Link
Unit is solid orange.
Control Center Connection Problems
Symptoms
From the Dual Link Control
Center, when I attempt to
connect to my service, I get
a connection timeout.
Dual Link Manager Connection Problems
Symptoms
I can't bring up the Dual
Link Manager from my
browser
Although your PC has a
USB port, the operating
system that is running
on your system does not
support its use.
The USB port on your
PC is not enabled.
The 3Com USB driver
did not install correctly
or the 3Com USB driver
is not running.
Possible Cause
The modem is not powered
on.
There's an Ethernet or USB
connection problem.
Possible Cause
The modem is not powered
on.
There's an Ethernet or USB
connection problem.
If you are running Microsoft
Windows 3.1, Windows 95, or
Windows NT, you will need to
upgrade your operating system to
Windows 98 or Windows 2000.
Verify that the USB port is
enabled by running the PC's
Setup program (typically the F1
or Delete key at boot). Refer to
your computer manufacturer's
documentation if you are having
trouble running the Setup
program or cannot find the USB
Configuration Settings section.
De-install then re-install the
3Com USB driver. (See the
driver installation procedure in
Your Installation Guide.)
Corrective Actions
Plug in the modem and allow it
sufficient time (about 1 minute) to
complete the boot process.
See previous sections in this
troubleshooting guide concerning
Ethernet or USB connection problems.
Corrective Actions
Power on the modem and allow it
sufficient time (about 1 minute) to
complete the boot process.
See previous sections in this
troubleshooting guide concerning
Ethernet or USB connection problems.