Drolet Heat Commander Installation And Operating Instructions Manual page 63

Table of Contents

Advertisement

Heat Commander Furnace Installation and Operation Manual
8. Install the new gasket on the glass. Remove a part of the paper
covering the gasket adhesive. Center the gasket on the edge
of the glass so that when folded and glued, the gasket is equal
on both sides. Do not stretch the gasket during installation.
Remove a majority of the paper, turn the glass to facilitate and
complete the installation of the gasket. When you return to the
starting point, cut the gasket so that the ends overlap by about
1/2" (13 mm).
9. Install the glass (E) and glass frame (D) centering them in the door frame. Install the
glass retainers (C) taking care not to over tighten the screws (B). Note that the two main
causes of glass breakage are unequal position in the door and screws too tight.
10. Install the new door gasket (A). To do this, use about 1/4" (6 mm) of adhesive to the
bottom of the groove that holds the gasket in the door. Then lay the new gasket starting
from the center of the hinge side and taking care not to stretch the gasket during
installation. Leave about 1/2" (13 mm) of gasket exceed the frame of the door. Once
jointed, push the fibers protruding towards the inside of the groove in the adhesive. Install
the door and let dry for 24 hours before using the
Do not abuse the glass door by striking or slamming shut. Do not use the furnace if the glass
is broken. To change the glass, perform the same operation described above.
10.1.5 Cleaning and painting the furnace
Do not attempt to clean or paint the furnace when the unit is hot. Painted surfaces can
be wiped down with a damp cloth. Plated or enameled surfaces may be scratched by
abrasive cleaners. To maintain the finish at its original brilliance, use only a damp soft cloth
to clean plated or enameled surfaces.
If the paint becomes scratched or damaged, you can give your wood furnace a brand-new
look by repainting it with heat-resistant or enamel finish paint. Before painting, roughen the
furnace.
63

Advertisement

Table of Contents
loading

This manual is also suitable for:

Df02003

Table of Contents