Drolet Heat Commander Installation And Operating Instructions Manual page 39

Heat Commander Furnace Installation and Operation Manual
2- From the thermostat connected to the existing furnace, connect 2 new wire (B) on the R
and W terminals of your thermostat and fix them to the terminal identified "I" (interlock) of
the parallel Add-On furnace.
EXISTING
FURNACE
When the wood furnace receives the signal from the existing furnace thermostat calls for
heat, combustion air controls will close slowly, the wood furnace burn rate will reduce to is
minimum. After the existing furnace thermostat is satisfied, the wood furnace will return
under the control of its own thermostat.
USA only
PARALLEL
ADD-ON
FURNACE
39