Table of Contents
Advertisement
Mechanical Installation
Summary
Connect Shipping Splits
Drive Mechanical Installation
The installation process is divided into three principal activities. The
mechanical installation process described in this chapter, the electrical
installation process described in
the electrical interconnection process described in
Interconnection on page
The cabinets must be arranged as shown in the Dimensional Drawing (DD).
Connect Shipping Splits
Affix Cabinets to Floor
Install Seismic Rated Enclosures
Install Main Cooling Fans
Install Power Modules (if applicable)
External Ducting
Follow all applicable guidelines for siting the components before continuing
with these installation instructions.
There may be some variation in the process depending on the type and number
of drive components in your particular installation.
ATTENTION: Install the drive on a level surface (+/- 1 mm per meter
[+/- 0.036 in. per 36 in.] of drive length in all directions). If necessary, use
metal shims to level the cabinets before joining them; attempting to level
after joining may twist or misalign the cabinets.
Connect DV/DT Filter Cabinet for A-Frame Drives
The standard A-Frame for PowerFlex 6000T drives comes fully assembled and
does not require any shipping splits. However, if a DV/DT filter is included
with the drive then there is one shipping split, and the drive and filter needs to
be connected as follows:
1. Remove the M16x16 countersunk screw that secures the LV covers and
grounding cover at the right side of the main drive, and the left side of
the filer cabinet. Then remove the covers.
2. Arrange the sections as described in the Dimensional Drawings and
move the sections together.
3. Align the cabinet side sheets together at the holes f
Rockwell Automation Publication 6000-IN100A-EN-P - August 2020
Drive Electrical Installation on page
47.
Chapter
33, and
Drive Electrical
9
13
16
23
26
30
r the hardware.
o
1
9
- Quick Links:
- Electrical Drawings
Hide quick links:
Advertisement
Table of Contents
