PPPoE Mode
Figure 16 PPPoE Screen
To setup the gateway for use with a PPP over Ethernet (PPPoE) connection, use the
following procedure:
1 Select the PPPoE is required radio button (See Figure 15) and then click Next.
2 Enter your PPP over Ethernet user name in the PPPoE User Name text box.
3 Enter your PPP over Ethernet password in the PPPoE Password text box.
4 Enter your PPP over Ethernet password again in the Confirm Password text box.
5 Enter your PPP over Ethernet service name in the PPPoE Service Name text box.
This is optional. Not all ISPs require a PPPoE service name.
Do not enter anything in this box if your ISP does not require a service name.
6 Check all of your settings, and then click Next.
Dynamic IP Address Mode
To setup the Gateway for use with a dynamic IP address connection:
1 Select the ISP provides configuration dynamically (via DHCP) radio button (See
Figure 15) and then click Next.
Figure 17 Hostname Screen
2 Enter the Host Name (optional). (Figure 17)
Some ISPs require a host name. If your ISP has this requirement, enter the host
name in the Host Name text box and click Next.
Accessing the Wizard
25