Samsung Galaxy Feel2 Instruction Manual page 13

4. Handling docomo nano UIM card
CAUTION
Be careful of the cut surface when handling a docomo nano
UIM card as it may damage a part of your body such as
Do
fingers, etc.
May cause injuries, etc. by the sharp cut surface.
5. H andling mobile phones near electronic medical
equipment
WARNING
Wearers of medical equipment such as implanted pacemakers
or defibrillators must carry and use the terminal at least 15
Do
cm away from the implanted device.
The terminal's signal may affect the performance of electronic
medical equipment.
When electronic medical equipment other than implanted
pacemakers or defibrillators are in use outside of medical
Do
facilities (such as in home care settings), check with the
device manufacturer to determine how the device is affected
by electrical signals.
The terminals signals may affect the performance of electronic
medical equipment.
Make sure that the terminal will not emit any signals (turn off
power, put it in Airplane mode, etc.) if within 15 cm of those
Do
around you, such as where crowded and you cannot move freely.
There may be wearers of medical equipment such as implanted
pacemakers or defibrillators around you. The terminal's signal may
affect the performance of electronic medical equipment.
When using the terminal in a medical facility, be sure to
observe the regulations of the facility.
Do
The terminal's signal may affect the performance of electronic
medical equipment.
6. Material list
Part
Display (touch screen)
Exterior case (side)
docomo nano UIM card/microSD card
tray
docomo nano UIM card/microSD card
tray (side)
docomo nano UIM card/microSD card
tray (waterproof packing)
Rear panel
Fingerprint sensor (center area)
Fingerprint sensor (surrounding area)
Power key/screen lock key, Volume
UP key/Volume DOWN key
Earpiece
Rear camera (lens panel)
Rear camera lens (surrounding area)
Flash/Light
USB Type-C jack
USB Type-C jack (surrounding area)
Headphone connection jack
Headphone connection jack
(surrounding area)
11
Material Surface treatment
Hardened glass AF coating
Aluminum Anodic oxidation
treatment
PC Laser engraved
Aluminum Anodic oxidation
treatment
Silicone -
Hardened glass Laminate (PET film)
+ AS coating
Epoxy Spray finish
Aluminum Anodic oxidation
treatment
Aluminum Anodic oxidation
treatment
Aluminum Anodic oxidation
treatment
Hardened glass -
Aluminum Anodic oxidation
treatment
Hardened glass -
Heat resistant -
plastic
PC -
Copper/titanium Nickel plating and
alloy Gold plating
PPA -
Contents/Precautions