Advertisement
IN100 Mortise Lock
12.
Installing Batteries
a. Place (6) "AA" alkaline batteries in the compartment, being
careful to align polarity properly (Fig. 18).
b. After batteries are installed, there is a slight delay; then red and
green flash, audible "beep" and lock motor will cycle.
13.
Inside Cover Installation
a. Assemble cover by hooking top edge on inside
mounting plate.
b. Carefully press bottom of cover toward door with
out pinching or damaging any wires.
c. Fully secure cover by tightening the security screw
at bottom of cover (Fig.19), utilizing a security
allen wrench.
Copyright © 2016 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
5) Installation Instructions (Continued)
19
Fig. 18
Fig. 19
Advertisement
