Advanced Parameter Setting For Remote Control - Acova FASSANE PREMIUM HORIZONTAL Instructions For Use Manual

5.3 Advanced parameter setting for remote control

WARNING!
Access to parameter setting is possible only when the remote control is off.
Some parameters on your remote control can be adjusted according to how you use it.
2
seconds
boost
mode
Parameter
number
boost
Back to
previous
mode
parameter.
No Parameter Description
0 Duration of Adjustable from 15 to 120 minutes in 15 minute steps
Boost
operation
1 Window open Value 0 (function disabled) or 1 (function enabled)
detection
2 Eco Value 0 (eco temperature unlinked) or 1 (linked eco-
temperature temperature setting: comfort T° minus 3.5°)
64
Press on P1P2 and
mode for 2 seconds
to enter.
Parameter
value
WARNING
It is essential to get
to the final "End" screen, to
confirm your parameter
Go to
changes.
the next
parameter.
Default
Setting
setting
60 Press the
1
Press the
1
Press the
No Parameter
3 Pilot wire
4 Ambient
temperature
calibration
5 Selection of
temperature
boost
sensor
mode
6 None
7
Re-pairing
radio-
!
frequency
8 Default display Value 0 (time) or 1 (temperature setting)
9 Display
version
number and
+ -
or key
reset
(unpairing).
+ -
or key
End Display
parameter
setting output
+ -
or key
After no key has been pressed for one minute, the remote control will automatically
quit the advanced parameters and turn off.
40019308 05/2019
Description
Value 0 (pilot wire disabled) or 1 (pilot wire enabled)
Adjustable from -5.0°C to 5.0°C in 0.5°C steps
Value 1 (receiver unit) or 2 (remote control)
See chapter 5.4
Value 0 (unpaired command) or 1 (paired command)
Back to factory settings
Warning!
All your settings as well as the pairing, will be deleted.
If the remote control was paired before the reset, the
receiver unit will also be reset.
Quit the settings menu
Default
Setting
setting
1 Press the + or - key
0.0 + -
Press the or key
1 or 2 + -
Press the or key
—
rF0 or Press on + or - key to*
rF1 re-pair an appliance
which was previously
paired but has lost the
link.
1 + -
Press the or key
x.xx Press on + key for 10
seconds to reset.
Short press on
mode or for
2 seconds on .
65