Hitachi S10mini Hardware Manual page 75

(15) Receiving task start factor (TASK FACT)
Setting value
0
01 to 16
• Operation
LGB editing operations are divided into selection type, setting type, and combination type
according to the items to be edited.
Selection type: The item to be edited is selected from the data menu.
Setting type: A numeric value is set within the range shown in the data menu.
Combination type: A setting pattern is selected from the data menu and a numeric value is
LGB MENU No.
As an LGB editing item, no item is included that sets the number of transfer
words.
Post-transmission data is transmitted and received only as much as specified
by JSND, JRCV (J_SND, J_RCV). For details, see Section 4.7, "Handlers."
Display data
Unused
01 to 16: (Start factor)
set according to the pattern.
0 Protocol type
1 Transmission frame
2 Transmission rate
3 Data change mode
4 Idling detection time
5 Start code
6 End code
7 BCC
8 Transmission delay time
9 Transmission break/restart code
A Transmission break monitoring time
B Output signal control
C Input signal check
D Receiving task number
E Receiving task start factor
Remarks
Initial value
Editing item
CAUTION
5-17
5 OPERATION
Operation type
Selection type
Selection type
Selection type
Selection type
Setting type
Combination type
Combination type
Selection type
Setting type
Combination type
Setting type
Selection type
Selection type
Setting type
Setting type