Hitachi S10mini Hardware Manual page 68

5 OPERATION
5.4.3 Defining a transfer area
• Setting the number of transfer words
Setting range
• Setting input and output transfer addresses
The input and output transfer areas used are always the following two areas: an XW area for input
and a YW area for output.
Set the input transfer address in the "XW□□0" format. Enter a value from 00 to FF for □□.
Set the output transfer address in the "YW□□0" format. Enter a value from 00 to FF for □□.
Setting range
/01 to /40
/00 to /FF
5-10