Table of Contents
Advertisement
2.2.1 FPL display specifications, and connector and MODE switch settings
USB connector
Power LED
•
Connector for target cable connection :
•
USB connector
•
Power LED
•
Status LED
Caution:
When the Status LED is blinking, communication with the target device is in
progress. Do not disconnect the target cable and USB cable.
•
MODE switch
Setting of the MODE switch
• MODE1 :
Used when V
• MODE2 :
Used when the FPL supplies power to a target system with 3.3 V V
(The V
• MODE3 :
Used when the FPL supplies power to a target system with 5 V V
(The V
• MODE4 :
Used when the FPL supplies power to a target system with 5 V V
and 3.3 V V
Chapter 2 Hardware Installation
Figure 2-2: Connector and LED Configuration
MODE switch
Status LED
Used to connect the connector of the target cable.
:
Used to connect the USB cable to be connected to the
host machine.
:
Turned on in green when the FPL is connected to the host
machine.
:
Blinks in red when the FPL is communicating with the
target device.
:
Switches power to be supplied to the target system.
Table 2-1: Settings on the rear of the housing
MODE
1
V
Target
DD
V
Target
DD2
/V
is supplied from the target system.
DD
DD2
pin is placed in the high-impedance state.)
DD2
pin is placed in the high-impedance state.)
DD2
.
DD2
Preliminary User's Manual U17271EE1V0UM00
Connector for target
cable connection
2
3
3.3 V
5 V
5 V
N.C.
N.C.
3.3 V
4
.
DD
.
DD
DD
17
Advertisement
Table of Contents
