Serial Port Connections - Hanbay RC AS-1.05 Series User Manual

HANBAY Inc
Connect the signal:
Locate the correct connection terminals as shown in the picture above then
connect your input signal on pos. 3 and 4 as shown below.
+
-
P2
RES
1 2 3 4 5 6
R66
ACTUATOR
RCx
Internal
Serial Port Connection:
Page 3 of 15
Rev.2018.1
SIGNAL GND
4 .. 20mA Signal source,
user powered
TD(A) TD(B)
User Manual RCx-xxxAS-1.05
NOTE 1: Usually, the actuators are shipped for
4 .. 20mA signal input.
For 1 ..5 V signal input, remove 250 ohm resistor
R66 (or cut just one wire as shown in picture on
page 2)
NOTE 2: ISOLATED
Signal Gnd is
I
Power Gnd. in all RCx-xxxS
www.hanbayinc.com
1 800 315 4461
hanbaysales@hanbayinc.com
from
models.