Kenwood XD-751 Instruction Manual page 11

FM indoor antenna
The accessory antenna is for temporary indoor use only. For stable
signal reception we recommend using an outdoor antenna. Remove
the indoor antenna if you connect one outdoors.
Speaker (left)
3 3
Speaker Unit
1
Twist
1 Strip the coating from the tip of cord and twist the
1 1
2 Connect to the antenna terminal.
3 Locate the position providing good reception condition.
4 Fix the antenna.
Before connecting the Front
Speakers
Stick the supplied front speaker pads to
the bottom of the front speakers to stabi-
lize the speakers and prevent them from
slipping.
Speaker cushion
2 3
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around
the unit (from the largest outer dimensions including projec-
tions) equal to, or greater than, shown below.
rear panel: 10 cm
conductor.
BASS REFLEX SPEAKER SYSTEM
The external view is variable depending on the model and
marketing destination area.
1. In case an associated system compo-
2. Never short-circuit the + and – speaker
3. If the left and right speaker connections
1. Be sure to insert all connection cords
4
2. Before plugging or unplugging a con-
System connection (XD-5...series)
XD-SERIES (En)
BASS REFLEX SPEAKER SYSTEM
Notes Notes
nent is connected, also read the instruc-
tion manual of the component.
cords.
or the + and – polarity are inverted, the
sound will be unnatural with unclear
positioning of musical instruments, etc.
Be sure to connect them without mis-
take.
Notes Notes
securely. If their connections are imper-
fect, the sound may not be produced or
noise may interfere.
nection cord, be sure to unplug the
power cord from the wall AC outlet. If
connection cords are plugged or un-
plugged with the power cord left plugged
in, malfunction or damage may result.
11