Changing Initial Setup [8 Speaker Setting] - Kenwood DV-S701 Instruction Manual

Changing initial setup [8 Speaker Setting]

The speaker setting made in the following is applicable only for Dolby Digital (AC-3) playback.
1
Perform steps 1 and 2 of the procedure in "Basic operation for changing the initial
setup".
2
Select the item to be set.
RC
1 Select an item with the cursor (%, fi, @, #) keys.
2 Press the ENTER key.
ENTER
GRC
ENTER
Enter
ENTER
Setting details
[Speaker mode setting]
This item allows you to set up whether each speaker type is used or
not in your system as well as the size of each speaker type.
The factory setup is as shown below.
÷ Front speakers (L/R)
÷ Center speaker
÷ Subwoofer
÷ Surround speakers (L/R) : Speakers displayed (Normal)
[Delay time setting]
This item allows you to provide the audio from the center and
surround speakers with delay effects to set their positions virtually
to the ideal positions. The factory setup is "0 ms" for both types of
speakers.
[Test]
This item allows you to output the built-in test signal from the
speakers. Use the test signal for setting the balance between
channels.
[Channel balance setting]
This item allows you to adjust the output level of each type of
speaker using the built-in test signal.
The output level must be adjusted from the listening position.
The factory setup is "0 dB" for all types of speakers.
Center speaker
Delay time (Center speaker)
Front speaker (L)
Speaker Setting
3.9
ms
L
Exit
Test
SL
+2 5.3
dB
Press RETURN to cancel
Surround speaker (L)
Channel balance (Surround L)
Delay time L/R
(Surround speakers)
Changing the initial setup
DV-S701 (En/E)
r
: Speakers displayed (Normal)
: Speaker displayed (Normal)
: Speaker displayed
Channel balance (Center speaker)
-3
C
Front speaker (R)
dB
R
Subwoofer
+1
SW
dB
Channel balance
(Subwoofer)
SR
+2
ms dB
Surround speaker (R)
Channel balance (Surround R)
53