Cd Synchronized Recording - Kenwood NV-500 Instruction Manual

Pause the recording (A.R.M.)
÷ Press the ¶REC key during recording. It stops after
leaving a non-recorded blank of 4 seconds. (Press the
key again to resume recording.)
Stop the recording
REC
REC
7
4. Set the recording condition.
1 Perform steps 2 to 4 of "Selecting the reverse mode" on page 25.
2 Perform steps 2 to 4 of "Selecting Dolby NR" on page 25.
5. Start recording.
Check that "Tape" is being displayed,
then press the REC button.
÷ Recording stops automatically when the tape side (s)
to be recorded have been fully recorded.

CD synchronized recording

When recording a CD, the playback of the source
and recording of the cassette deck can be synchro-
nized by putting the cassette deck in record-pause
mode. (Sync recording)
1 Put the CD recorder in pause mode.
2 Select the music to be recorded by using the
skip key (4 or ¢). (The tape pauses at the
beginning of the selected music.)
3 Put the cassette deck in record-pause mode.
4 Start playback of the CD. (Sync recording
starts.)
÷ Press the stop key (7) of the CD player to stop
recording.
Displayed when Dolby NR is selected
Recording indicator
tape transport
direction indicator
Let's recording
Reverse mode indicator
TV
VIDEO1
VIDEO2
CD
TUNER
TAPE
FUNCTION
When the remote control unit is
attached to the main unit:
Tape counter
When it is detached from the main
unit: "Stop" for stop,
"Play" for playback,
"Rec Pause" for record pause,
"A.R.M." during A.R.M. op-
eration.
27