Kenwood NV-500 Instruction Manual page 58

58
CD player section
Symptom
A CD is placed in the player
but it cannot be played.
Sound is not produced.
Sound skips.
"Text Full" is displayed
Remote control unit
Symptom
Remote control operation is
not possible.
The "Low Battery" alarm is
displayed.
Cause
÷ The disc is placed upside down.
÷ The disc position is displaced.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ Dew is condensed on the optics lens.
÷ The disc has not been placed.
÷ The player is not put to the play mode.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ The disc is dirty.
÷ The disc is scratched.
÷ The player is subject to vibration.
÷ Too much text data has been stored.
Cause
÷ Batteries are exhausted.
÷ The remote control is too far away from
the system, the controlling angle is devi-
ated or there is an obstacle in between.
÷ The component to be played is not loaded
with a CD or cassette tape.
÷ Batteries are exhausted.
In case of difficulty
Remedy
÷ Place the disc properly, with the label
side facing upward.
÷ Place the disc properly.
÷ Clean the disc referring to "Disc han-
dling precautions".
÷ Try another disc.
÷ Refer to "Caution on condensation" and
remove the condensation by evaporation.
÷ Place a disc in the CD player.
÷ Press the 6 key.
÷ Clean the disc referring to "Disc han-
dling precautions".
÷ Try another disc.
÷ Clean the disc referring to "Disc han-
dling precautions".
÷ Try another disc.
÷ Install the unit in a place not subject to
vibrations.
÷ This is not a malfunction.
Remedy
÷ Replace with new batteries.
÷ Operate the unit inside the remote con-
trollable range.
÷ Load a CD or cassette tape in the com-
ponent to be played.
÷ Replace with new batteries.
T
R
T
T
@
@
@