Safety Information ...........................3 1.0 Installation of 3M Static Control Anti-Fatigue Mats 9900 and 9920 ........4 ™ 2.0 Installation and Assembly of 3M Static Control Anti-Fatigue Mat Runner 9910 ....5 ™ 3.0 Optional Permanent Bonding of Runner Sections with Adhesive ..........7 4.0 Cleaning Guidelines ........................9...
™ requiring insulating type matting: • 9900 Series Mats are electrically conductive -- do not use these mats in areas with possible exposure to high voltage. To reduce the risk associated with hazardous voltage due to 9900 Series Mats being installed with an incorrect grounding lead: •...
™ WARNING To reduce the risk associated with hazardous voltage due to 9900 Series Mats being used in areas requiring insulating type matting: • M 9900 Series Mats are electrically conductive -- do not use this matting in areas with possible exposure to high voltage.
To reduce the risk associated with hazardous voltage due to 3M™ Anti-Fatigue Mats 9900 Series being used in areas requiring insulating type matting: • M 9900 Series Mats are electrically conductive -- do not use this matting in areas with possible exposure to high voltage.
Page 6
The ESD flooring may be able to provide a sufficient ESD ground path for the mat. Verify the surface to ground resistance following measurement method outlined in ESD Standard ANSI/ESD S7.1. This can be done using the 3M Test Kit 701, which includes a ™...
3.0 Optional Permanent Bonding of Runner Sections with Adhesive WARNING To reduce the risk associated with back strain due to the heavy weight of the mats: • Follow safe lifting procedures during installation or moving. Note: Permanent adhering of the runner sections together with an adhesive may create a continuous runner that is very heavy and difficult to move or reposition.
Page 8
4. As necessary, apply localized pressure to close the adhered seam. It may be necessary to hold pressure for 10-15 seconds until the adhesive bonds the two pieces. (Figures 6 & 7) Fig. Fig.7 5. The beveled edges of the seam are adhered separately. Pull the beveled edge up to expose its edge and apply adhesive then push the two beveled edges of the adhered sections together.
® ® Note: 3M Static Control Anti-Fatigue Mats 9900 Series are constructed of durable SBR rubber that can ™ be easily cleaned with readily available cleaners and techniques. Clean mats as needed. The following recommendations are provided to prolong the life of your mat product: 1.
™ High-performance, all-purpose cleaner. First choice for your every day cleaning needs. For floors, walls and other non-porous surfaces. Contact: 3M Commercial Care Division 1-800-852-9722 www.3M.com/commcare Ground Cord 3040, 15 ft. with 10 mm Snap ™ Molded-in male snap fastener with integral 1-megohm resistor on one end, solderless terminal on other.
6.0 Specifications Static Control Anti-Fatigue Mats 9900 Series ™ Product Number Description 3M ID Number 9900 ft. x ft. (0.9 m x 1. m) Static Control 9-079--1 Anti-Fatigue Mat 9910 ft. by custom length Static Control Anti-...
Page 12
IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Except to the extent prohibited by law, 3M will not be liable for any loss or damage arising from this 3M product, whether indirect, special, incidental, consequential or punitive regardless of the legal theory asserted.