Recycling The Clippings; Bagging The Clippings; Side-Discharging The Clippings - Toro 20959 Operator's Manual

Recycling the Clippings

Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine, remove it;
refer to Removing the Grass Bag (page
side-discharge chute is on the machine, remove it;
refer to Removing the Side-Discharge Chute (page
12).

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove
it; refer to Removing the Grass Bag (page
Installing the Grass Bag
1. Raise and hold up the rear deflector
Figure 17
1. Rear deflector
2. Notch (left side notch not
shown)
2. Install the grass bag, ensuring that the pins on
the bag rest in the notches on the handle
17).
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps above.
12). If the
12).
(Figure 17).
g189040
3. Grass bag pin (2)
(Figure
Side-Discharging the
Clippings
Use side-discharging for cutting very tall grass.
If the grass bag is on the machine, remove it before
side-discharging the clippings; refer to
Grass Bag (page 12).
Installing the Side-Discharge
Chute
Unlatch and lift up the side deflector and install the
side-discharge chute
Removing the Side-Discharge
Chute
To remove the side-discharge chute, lift up the side
deflector, remove the side-discharge chute, and lower
the side-discharge deflector until it latches securely.
12
Removing the
(Figure 18).
Figure 18
g235646