Starting Engine (Button Type-Smart Key) - Hyundai HDFN35T Operation And Maintenance Manual

STARTING ENGINE (BUTTON TYPE-SMART KEY)

1. Put the marine gear into "neutral position" by means of gear separation button.
2. Press 1 time the "START" button on engine operation panel
(Automatically all lamps are light on for 1 second)
3. Automatically fuel solenoid valve is operated and operate pre-heating system for 9 seconds and then starter motor
rotate the engine. (Do not operate glow plugs continuously for more than 180 seconds and the starter should not
work for more than 20 seconds continuously.)
4. Automatically operate the after-heating system for 8 seconds to reduce exhaust gas.
5. Run at a idle speed until the engine reaches a normal operating temperature before doing work
- If you do not want to engine pre-heating, push the start button three times continuously
within 1 second and then engine will be starting without pre-heating.
- Verify that the oil lamp, water lamp and charge lamp lights are off after run the engine. If
either light is on, stop the engine immediately.
- To secure long life and maximum power it is recommended to run the engine for the
first 25 hours at not more than 80% of the maximum output.
- Do not run the engine over idle speed (about 1000 rpm) and 5 minutes without
supplying it with cooling water or seawater. Either the engine seawater pump will be
damaged or the engine will be damaged from overeating. Before starting the engine, be
sure to supply seawater or cooling water with provided auxiliary device to the seawater
pump.
7