Tektronix 11A34 User Reference Supplement page 20

Probe ID
4 .
5 .
Front-Panel Error Messages
Message:
Cause:
Message:
Cause:
3 .
Probe ID Utility menu. Autos-et is the automatic setup of vertical
display, e.g., two to five divisions of vertical deflection
repetitions of the input signal. For more information, refer to Autoset in
the 11301 and 11302 User's Referqrce manual.
using the Probe ID utility menu. such xne asuremen~ are peak-topeak,
maximum, middle, and minimum voltages; frequency, period,
and duty cycle. For full information about automatic measurements,
Measure in the 11301 and 11302 User's Reference manual.
An interrupt to the GPIB and M-232-C
232-C For more information, refer to the GlTE/RS3ZC
and 11302 User's Reference manual.
Internal DAC overflow on channel N of LEFT, CENTER, or RIGHT
plug-in unit, where N = 1,2,3, or 4.
hardware. Jn this situation, the plug-in unit sets the DAC to the
limit nearer the rquestecl setting.
RIGHT plug-in unit, where N = 1,2,3 or4.
improperly cormacted.
or ken
and
two to five
feature can be enabled or disabled
part of the 11301
see