Application Data - GE IS200ADIIH A Series Manual

Fault Fault Name
No.
359 FLT_LINK_LOS
(May be set up to
monitor
AUXCMD.00 bit.
If AUXCMD.00 =
0, the cause fault
FL359.) *
446 FLT_LADIINIT
447 FLT_LADIIWDG
448 FLT_LADIIRTM
449 FLT_LADIISEL
* = AUXCMD.00 will be set if the LCP is interrupted by the ADII board's interrupt line (the ISBus controller received
data from the master), AUXCMD.00 will be cleared if the interrupt does not happen for 80 ms.

Application Data

GEI-100305
Table 6. Fault Codes for ADII Board and ISBus Interface
Description
The ISBus controller is not receiving
data from the ISBus LAN.
(LCP ADII interrupt is not being
triggered)
ADII board failed initialization
ISBus controller and/or LCP has failed
the watchdog
ADII board run time fault
The ISBus controller has a fault or LCP
has detected a problem with the ADII
board or ISBus controller interface.
Another drive LAN is enabled besides
ISBus.
The ADII board has no fuses or hardware jumpers. The ADII board has LED
indicators and testpoints for diagnostic and setup purposes. Any ISBus or ADII
board faults will be displayed on the drive's display. The testpoints on the ADII
board are for manufacturing, diagnostic, and setup purposes. See Figure 2 for the
locations of these devices.
Corrective Action to Take
Check to make sure there is a master
controller on the ISBus and that it is
communicating.
Check ADII board JP1 for a 1-2
connection.
Check/replace LNPL and 2PL connections
and cables.
Check the ISBus connections (RJ45 – P2
& P3)
Replace ADII board
Check/replace LNPL and 2PL connections
and cables.
Replace ADII board
Check/replace LNPL and 2PL connections
and cables.
Check the ISBus connections (RJ45 – P2
& P3)
Replace ADII board
Check/replace LNPL and 2PL connections
and cables.
Check the ISBus connections (RJ45 – P2
& P3)
Replace ADII board
Modify the drive's parameters (EEROM)
to disable the other LANs
DLAN
DLAN +
GENIUS
ADCI
(CPL/CBUS/FBUS)
Auxiliary Drive to ISBus Interface Board IS200ADII • • • • 9
– LCPJP1.0 (EE615.0 ) = 1
– ARCJP1.0 (EE706.0) = 0
– GENJPR.0 (EE725.0) = 0
– LCPJP3.0 (EE617.0) = 0