Brother TN-310BK Remanufacturing Instructions page 6

D
isassembling The
7. Place a slotted screwdriver into the opening directly in front of the
developer roller stabilizer. Gently press on the stabilizer to release
(Figure 7a). Rotate the developer roller stabilizer out and down as
shown in Figure 7b.
Developer Roller
Stabilizer
Figure 7a
Developer Roller Stabilizer
8. Lift the developer roller slightly to remove the drive gear. Remove the
drive gear and toner adder roller gear in the order shown in Figure 8.
Drive Gear
1
Toner Adder Roller Gear
9. Remove the developer roller by grasping the ends of the roller and
pulling out and away from the cartridge as shown in
Figure 9.
Developer Roller
C
arTriDge
Slotted
Screwdriver
Slotted Screwdriver
Figure 7b
2
Figure 8
Figure 9
10. Blow with dry, filtered, ionized, compressed air (Figure 10).
Developer Roller
11. Using a lint-free cloth dampened with 91-99% isopropyl alcohol,
gently clean the developer roller using end-to-end strokes. Using
another lint-free cloth, dampened with de-ionized water, gently wipe
the developer roller as shown in Figure 11. Blow with dry, filtered,
ionized, compressed air.
Lint-Free Cloth
Figure 11
Air Gun
Figure 10
Developer Roller
sss 1143
™
6
page