Table of Contents
Advertisement
D
isassembling The
Note: Notice the Replace Drum message on the printers display screen.
1.
Using a Phillips screwdriver remove the five screws from contact and
drive sides end plates of the drum unit (Figures 35a and 35b).
Screws
Phillips
Screwdriver
2.
Remove both end plates as shown in Figures 36a and 36b.
Figure 36a
Drive Side
End Plate
Figure 36b
D
rum
Contact Side End Plate
Phillips
Screwdriver
Figure 35a
Drive Side End Plate
Screws
Figure 35b
Drive Side
End Plate
Drum Unit
Contact Side
End Plate
u
niT
3.
Using a small slotted screwdriver remove the white drum bearings on
the drive side of the drum unit and set aside (Figures 37a and 37b).
Drive Side
Drum Bearing
Drive Side Drum Bearings
Figure 37b
4.
Lift the drum drive gear up to disengage from the cleaning roller
drive gear (Figure 38a). Use a slotted screwdriver to push the contact
side of the drum towards the drive side (Figure 38b).
Drive
Side
Drum Drive Gear
Drive
Side
Figure 38b
Drive
Side
Slotted
Screwdriver
Figure 37a
Drive
Side
Figure 38a
Contact
Side
Slotted Screwdriver
sss
1143
™
13
page
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
