Nstalling The D Rums - Brother TN-310BK Remanufacturing Instructions

i i
nsTalling The nsTalling The
Note: The following steps should be completed for each drum before the drum unit is assembled.
10. Using a lint-free swab, apply conductive lubricant to the end of
the contact side drum bearings and install each bearing onto the
replacement drums (Figures 43a and 43b).
Lint-Free Swab
Figure 43a
Drum
Figure 43b
11. Install the drum onto the drum unit by sliding the drum drive side end
into the drum unit first (Figure 44).
Wiper Tab
Figure 44
Note: Ensure the small, transparent, plastic, wiper tabs are
positioned on top of all the drums.
D D
rums rums
Contact Side
Drum Bearing
Contact Side
Drum Bearing
Drum
Drum Unit
12. Rotate the drum contact bearing until the larger locking tab is
positioned at the top and set the contact side of the drum into the
drum unit Figures 45a, 45b and 45c.
Drum
Figure 45b
Large Locking Tab
Small Locking Tab
Figure 45a
Drum
Figure 45c
sss 1143 15
™
page