Page 1
IMPORTANT – FOR FUTURE REFERENCE. READ CAREFULLY SUFFOCATION HAZARD Infants have suffocated: In gaps between extra padding and side of the bassinet on soft bedding. Dream On Me. ENTRAPMENT HAZARD:...
4 sides. there are any signs of damage. DO NOT substitute parts. ・ALWAYS push adult mattress against beside sleeper after • Contact Dream On Me if replacement parts or instructions are securing to bed with safety strap and fixing buckles. needed.
Page 3
A1. Height adjuster button B1. Fixing pin COMPONENTS A2. Middle support frame release button C3. Belt length adjust buckles Please check to make sure that all of the following parts listed below A3. Adjustable feet with wheels E1. Belt with clip are included in the box when opened.
Page 5
To Fold and Store the Bedside Sleeper 9. To fold and store, remove parts B, D, and G and adjust the height at the lowest position. Next, place the mattress pad on the floor and place part G diagonally across as shown below. Next, fold the beside sleeper and place it on top of part D and G as shown below.
Page 7
2. Slide the top bar lock lever and lift the top bar out of the grooves on both sides and fold down.
Page 8
6. Pass the fixing belt under the bed to the other side of by pulling belts firmly until the straps are in the correct position as shown in the images below. IN THE BEDSIDE SLEEPER MODE , THE TWO LEGS OF THE BEDSIDE SLEEPER SHOULD ALWAYS BE ADJUSTED TO THE SAME HEIGHT.
Page 10
Dream On Me Inc. each wash check the resistance of the fabric and of the stitching. 1532 S Washington Ave Piscataway Twp. NJ 08854 ARNING: During the removal/or application of the lining, handle the Tel: 732-752-7220 fabric carefully in order to avoid accidental damage or tears.
Need help?
Do you have a question about the 387 and is the answer not in the manual?
Questions and answers