Haier HD90-A636 User Manual page 27

GB
Problem
Drying time is
too short.
Creasing at the
laundry.
Door does not
close.
Remaining time
on the display
stops or skips.
The drum interi-
or light does not
work.
In case of power failure
In case of power failure, the current programme is stored only for a short time. Usually, a
restart of the programme is required.
WARNING!
Quickly remove all items and spread them out that the heat can be released.
Possible cause
• The load was too small?
• The laundry was too dry?
• The tumble dryer is overloaded?
• The right programme was se-
lected?
• Laundry is clamped between
door and gasket?
• The remaining time will be ad-
justed continuously
upon the following factors:
- Type of laundry.
- Loaded amount.
- Moisture degree of the laundry.
- Ambient temperature.
• Appliance is connected to the
power supply?
• The appliance
switched on?
• The light bulb is still functional?
Troubleshooting
Possible solution
• For single items or small
amount of laundry the TIMER
programme should be selected.
• Select the TIMER programme
or a higher dry level.
• Reduce the amount of laundry.
• Remove laundry immediately
after programme end, hang
them up and pull them into
shape.
• Select and adjust the pro-
gramme according to the fab-
ric type.
• Insert laundry correctly.
• The automatic adjustment is a
based normal operation.
• Check power supply
• Switch the machine on.
has been
• Contact the customer service
to replace the lamp.
27