Table of Contents
Advertisement
The Model 1206 Dispense Valve is engineered for applications which require volumetric consistency. The
1206 allows operation with material supply pressures up to 100 psi (6.9 bar). Material viscosity dispensing
capabilities range from very thin material to high-viscosity epoxies and metal filled pastes with viscosities
above 1,000,000 cps (1000 Pa•s). The Model 1206 ships complete with the following:
Model 1206 Dispense Valve
Two 3-foot (.9m) sections of Pneumatic Air Line
Seal Kit
Luer Lock Needle Adapter
Operating and Maintenance Manual
This product should be used only by employees who have been given appropriate training and safety
warnings as set forth in this manual. Read completely before operating.
WARNING: Do not exceed 100 psi (6.9 bar) air pressure to the dispense valve. Do not exceed 100 psi (6.9
bar) material inlet pressure to the dispense valve; higher pressures may cause a hazard or serious injury.
Note: The recommended pneumatic operating system pressure is 70 psi (4.8 bar) clean/dry air, if your system
uses a syringe feed; do not exceed 60psi (4.1 bar) air pressure to the syringe inlet.
Toxicity and flammability hazards depend upon the product being dispensed by this unit, and the user should
take appropriate safety precautions as indicated on the MSDS of the product.
Always wear safety glasses.
Throughout this manual you will find references by illustration item number to the illustrations in the manual.
The references are indicated by parentheses around a number such as: (7). Illustrations represent typical
valve configurations. The drawings for your exact model are inserted at the back of the manual and include
the part numbers for ordering replacement parts.
GENERAL INFORMATION
SAFETY INFORMATION
ILLUSTRATION REFERENCES
Page 3
Advertisement
Table of Contents
