Adjusting The Self-Propel Drive - Toro 20955 Operator's Manual

Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1. Turn the adjustment knob counterclockwise to
loosen the cable adjustment
Figure 41
1. Handle (left side)
2. Adjustment knob
3. Self-propel-drive cable
2. Adjust the tension on the cable
pulling it back or pushing it forward and holding
that position.
Note:
Push the cable toward the engine to
increase the traction; pull the cable away from
the engine to decrease the traction.
3. Turn the adjustment knob clockwise to tighten
the cable adjustment.
Note:
Tighten the knob firmly by hand.
(Figure 41).
g027231
4. Turn the knob clockwise to
tighten the adjustment.
5. Turn the knob
counterclockwise to
loosen the adjustment.
(Figure 41) by
25