Using The Self-Propel Drive; Shutting Off The Engine; Recycling The Clippings - Toro 20955 Operator's Manual

Figure 20
Note:
When you pull the recoil-start handle,
pull it lightly until you feel resistance, then pull it
sharply (Figure 20). Allow the rope to return to
the handle slowly.
Note:
If the machine does not start after several
attempts, contact an Authorized Service Dealer.

Using the Self-Propel Drive

To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the machine will automatically keep pace
with you (Figure 21).
Figure 21
Note:
If the machine does not freely roll backward
after self-propelling, stop walking, hold your hands
in place, and allow the machine to roll a couple of
centimeters (inches) forward to disengage the wheel
drive. You can also try reaching just under the upper
handle to the metal handle and pushing the machine
forward a couple of centimeters (inches). If the
machine still does not roll backward easily, contact an
Authorized Service Dealer.

Shutting Off the Engine

Service Interval: Before each use or daily—Ensure
To shut off the engine, release the blade-control bar.
Note:
Remove the electric-start button (if equipped)
whenever you leave the machine.
g009548
Important:
When you release the blade-control
bar, the engine should shut off and the blade
should stop within 3 seconds. If they do not, stop
using your machine immediately and contact an
Authorized Service Dealer.

Recycling the Clippings

Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position,
move the lever to the recycling position; refer to
Operating the Bag-on-Demand Lever (page
the side-discharge chute is on the machine, remove
it; refer to Removing the Side-Discharge Chute (page
17).
g009549
15
that the engine shuts off within
3 seconds after releasing the
blade-control bar.
16). If