Adjusting The Handle Height; Adjusting The Cutting Height - Toro 20955 Operator's Manual

Adjusting the Handle
Height
You can raise or lower the handle in 1 of 2 positions
that is more comfortable for you
Figure 15
1. Loosen both handle knobs until you can push
the square edges of the carriage bolts out of the
square holes in the handle brackets.
2. Push the knobs until they are loose.
3. Move the handle to the upper or lower height
position.
4. Pull the knobs until the square edges of each
carriage bolt fits into its related square hole.
5. Tighten the handle knobs as tight as you can.
(Figure 15).
g032867
12
Adjusting the Cutting
Height
WARNING
Adjusting the cutting height may bring you
into contact with the moving blade, causing
serious injury.
• Shut off the engine and wait for all moving
parts to stop.
• Do not put your fingers under the housing
when adjusting the cutting height.
CAUTION
If the engine has been running, the muffler
will be hot and can severely burn you.
Keep away from the hot muffler.
Adjust the cutting height as desired. Set all the wheels
to the same height; refer to
Figure 16
1. Raise the machine
Figure 16.
g027451
2. Lower the machine